塔河油田一号联合站污水处理试验研究

塔河油田一号联合站(塔一联)稠油污水具有粘度大、油水密度差小、乳化严重等特点,它的回用与外排具有一定的难度.通过实验室和现场试验研制开发的破乳剂和混凝剂,强化了除油效果,减轻了过滤系统的负荷,处理污水达到了注水水质指标.     

上悬窗条件下通风控制腔室火灾温度的实验研究

随着建筑结构的发展,上悬窗日益成为城市建筑窗户的选择,但这种通风条件下腔室火灾的发展特性仍缺乏研究。利用1∶8相似比例的缩尺寸腔室火灾实验台,实验研究了上悬窗不同开口尺寸、不同开窗角度下,通风控制的腔室火灾温度发展特性。实验结果表明,通风控制条件下,腔室火灾温度随着上悬窗开口尺寸和开窗角度的增加而增加,并通过能量平衡分析,建立了通风控制条件下,耦合上悬窗尺寸和开窗角度因素的腔室内部火灾温度预测模型。     

基于熵权物元可拓模型的智慧档案馆安全评估

为了评估智慧档案馆的安全状况,预防安全事故发生,通过分析智慧档案馆的安全因素,构建了由8个一级指标、38个二级指标构成的智慧档案馆安全评估指标体系,并将信息熵理论和物元可拓理论有机结合,构建了智慧档案馆安全熵权物元多级可拓评估理论模型。应用该指标体系和理论模型对某档案馆进行了实证研究,得出其安全等级为V级(安全),为该馆针对性地提出了加强安全工作的整改建议。评估结果与实际情况一致,验证了该评估指标体系和评估理论模型的正确性和可靠性。     

基于系统动力学的食品企业安全生产监管博弈研究

为了研究食品安全生产及监管的内在机理、影响因素及监管模式,采用演化博弈论方法建立了政府监管部门与食品企业之间的博弈模型,运用复制动态方程和系统动力学方法深入分析了食品安全生产中相关主体的决策选择。结果表明:食品企业在追求利益最大化的前提下须主动重视食品安全问题,食品企业的策略选择受安全生产投入成本、处罚成本和声誉收益的影响;政府监管部门的监管行为受监管成本、外部负效益及社会成本等多方因素的影响。因此,增大监管部门惩处力度、降低监管成本、完善社会公众监督机制、强化声誉效应是食品安全问题得以解决的有力保障。     

污泥干化使重金属形态变向稳定的原因分析

在模拟条件下对不同类型污泥进行连续干化,研究了不同干化温度下污泥重金属存在形态的分布特征.同时,通过测定污泥含水率、密度、温度和电导率等物性参数,分析了污泥干化过程重金属形态向稳定态转变的原因.结果表明,污泥中重金属存在形态的分布特征因污泥类型及来源不同而具有明显的差异;污泥干化过程可以使酸溶态、可还原态和可氧化态重金属向残渣态重金属转变;干化过程中污泥物性的改变和部分有机质和硫化物的分解是引起污泥重金属存在形态发生变化的主要原因.研究结果对于深入了解污泥中重金属的环境地球化学行为具有重要的理论意义,同时还可为污泥无害化、减量化和资源化的最终处理提供科学依据.     

组合人工湿地对城镇污水处理厂尾水中有机物的去除特征研究

采用物理分级和三维荧光光谱法,研究了组合人工湿地对城镇污水处理厂尾水中不同形态有机物的去除特征.结果表明,组合人工湿地对污水处理厂尾水具有较好的深度处理效果,出水水质基本可以达到国家地表水环境质量标准(GB38382-2002)Ⅲ或Ⅳ类水标准.组合人工湿地处理系统对尾水中CODCr和BOD5总体去除率分别达到35.2%和44.3%,对尾水中总有机碳(TOC)、溶解性有机碳(DOC)、颗粒有机碳(POC)的平均去除率分别为46.9%、45.9%、48.3%.组合人工湿地系统不同单元对尾水中有机物的去除贡献率存在差异,其中,潜流湿地单元对尾水中CODCr和BOD5及其不同组分有机碳的去除效率较高.试验期间,由于藻类滋生,表流湿地单元出水中有机物含量波动较大,去除效果明显降低,藻类被打捞后,出水水质明显改善.三维荧光光谱分析结果显示,各个处理单元取样点的水样三维荧光光谱均出现4个明显的荧光峰.人工湿地各单元出水溶解性有机质(DOM)中,类蛋白和类腐殖酸物质含量较高,类富里酸物质含量较低.人工湿地对类蛋白和类腐殖酸物质有较强的去除作用.     

污泥对樟子松生物量及其重金属积累和土壤重金属有效性的影响

采用盆栽试验研究了不同剂量污泥(体积分数,即污泥体积占污泥和沙土总体积的百分比,分别为:0、20%、33.3%、50%和100%)施用于风沙土条件下,污泥剂量对樟子松幼苗生物量及其对重金属的累积和土壤中重金属有效性的影响.结果表明,在养分含量低的风沙土中,施用污泥能够显著提高樟子松幼苗生物量,最适剂量为50%;污泥剂量的增加可促进樟子松植株对重金属的吸收和累积,在最适剂量(50%)条件下,樟子松植株中Cu、Cd、Pb、Zn的累积量分别是对照(不施污泥)的18.0、8.9、17.1、11.5倍;樟子松植株重金属吸收速率顺序为:ZnCuPbCd,而迁移系数顺序为:ZnCdCuPb;土壤中有效态重金属含量随污泥剂量的增加而增加,而植株收获后土壤中有效态重金属下降幅度均小于对照.     

Modeling the e ects of constructed wetland on nonpoint source pollution control and reservoir water quality improvement

This article describes the integrated modeling approach for planning the size and the operation of constructed wetlands for maximizing retention of nonpoint source pollutant loads and reservoir water-quality improvement at a catchment scale. The experimental field-scale wetland systems (four sets, 0.88 ha each) have been in operation since 2002, where water depth was maintained at 30–50 cm and hydraulic loading rate was at 6.3–18.8 cm/day. The wetland system was found to be adequate for treating polluted stream water with stable removal e ciency even during the winter. The integrated modeling system (modified-BASINS) was applied to the Seokmoon estuarine reservoir watershed and calibrated with monitoring data from constructed wetland, stream, and reservoir. The calibrated integrated modeling system estimated that constructing wetlands on 0.5% (about 114 ha) of the watershed area at the mouth of reservoir could reduce 11.61% and 13.49% of total external nitrogen and phosphorus loads, respectively. It also might improve the nitrogen and phosphorus concentration of the reservoir by 9.69% and 16.48%, respectively. The study suggested that about 0.1%–1.0% of the watershed area should be allocated for constructed wetland to meet specified water-quality standards for the estuarine reservoir at the polder area where land use planning is relatively less complicated.     

Evaluation of mercury speciation and removal through air pollution control devices of a 190 MW boiler

Air pollution control devices (APCDs) are installed at coal-fired power plants for air pollutant regulation. Selective catalytic reduction (SCR) and wet flue gas desulfurization (FGD) systems have the co-benefits of air pollutant and mercury removal. Configuration and operational conditions of APCDs and mercury speciation a ect mercury removal e ciently at coal-fired utilities. The Ontario Hydro Method (OHM) recommended by the U.S. Environmental Protection Agency (EPA) was used to determine mercury speciation simultaneously at five sampling locations through SCR-ESP-FGD at a 190 MW unit. Chlorine in coal had been suggested as a factor a ecting the mercury speciation in flue gas; and low-chlorine coal was purported to produce less oxidized mercury (Hg2+) and more elemental mercury (Hg0) at the SCR inlet compared to higher chlorine coal. SCR could oxidize elemental mercury into oxidized mercury when SCR was in service, and oxidation e ciency reached 71.0%. Therefore, oxidized mercury removal e ciency was enhanced through a wet FGD system. In the non-ozone season, about 89.5%–96.8% of oxidized mercury was controlled, but only 54.9%–68.8% of the total mercury was captured through wet FGD. Oxidized mercury removal e ciency was 95.9%–98.0%, and there was a big di erence in the total mercury removal e ciencies from 78.0% to 90.2% in the ozone season. Mercury mass balance was evaluated to validate reliability of OHM testing data, and the ratio of mercury input in the coal to mercury output at the stack was from 0.84 to 1.08.     

Classification of different sustainable flood retention basin types

Using a revised version of a previously published expert classification system, a database of potential Sustainable Flood Retention Basins has been developed for Scotland. The research shows that the majority of small and former (often old) drinking water reservoirs are kept full and their spillways are continuously in operation. Utilising some of the available capacity to contribute to flood control could significantly reduce the costs of complying with the European Union Flood Directive. Furthermore, the application of a previously developed classification model for Baden in Germany for the Scottish data set showed a lower diversity for basins in Scotland due to less developed infrastructure. The classification system appears to be robust and has the potential, with minor modifications, to be applied across Europe. The principle value of this approach is a clear and unambiguous categorisation, based on standard variables, which can help to promote communication and understanding between stakeholders.